Five-axis CNC Machining Introduction All models of five-axis machining must be semi-finished, and can be finished after semi-finishing. The precision and accuracy of finishing is determined by the position of the model on the vehicle.

The processing principle of the outer cover mold:

Since the outer cover itself is not allowed to have tiny convex hulls, pits, small wrinkles, cracks and other defects, this kind of parts requires high surface quality and good profile dimensional accuracy. Therefore, mold surface processing should be guaranteed from two aspects: smoothness and surface processing accuracy. Try to complete it in one cut. When you must connect the knife, you must be in an uncritical position. After processing, try to reduce the amount of fitter's grinding. In principle, only rubbing is allowed.

Five-axis CNC machining Five-axis machining operation planning:

Five-axis CNC machining should formulate a series of practical and effective operating procedures in the use and management of five-axis machining centers. For example, lubrication, maintenance, reasonable use and standardized shift system are the main contents of the use and management of five-axis CNC machine tools. Formulating and complying with operating regulations is one of the important measures to ensure the safe operation of a five-axis machining center. Practice has proved that many failures can be reduced or avoided by observing the operating procedures.

It is not suitable for long-term storage. When there is no processing task, the machine tool should be energized regularly, preferably 2 to 3 times a week.

Run dry for about 1 hour each time to use the heat of the machine tool to reduce the humidity in the machine and make electronic components.

It will not get damp, and at the same time, it can detect whether the battery is low and alarm in time to prevent the loss of system setting parameters.